Honeywell WEBsAX Series Mounting & Wiring Manual page 23

NXS BIOS Settings
Table 5 provides a list of BIOS settings for a NXS—including those that require settings from "default" values. Default
values can become effective if the backup battery goes bad, or whenever the battery is replaced.
Print out the table below and keep the pages in a safe place, for future reference.
Tip
Table 5 NXS required BIOS settings
Menu SubMenu
—
Boot
options
Main
Keyboard
Features
Hardware
Options
—
System Parameters
System Time
System Date
Primary Master
Primary Slave
Secondary Master
Memory Cache
Quick Boot Mode
SETUP prompt
POST errors
Summary screen
Num Lock
Keyboard auto–repeat
rate
Keyboard auto–repeat
delay
Eth 1 Address
Eth 1 Remote Boot
Eth 2 Enable
Eth 2 Address
Eth 2 Remote Boot
PCI – MPI/DP
Boot Display
System Memory
Extended Memory
Defaults
hh:mm:ss
MM/DD/YYYY
40008 MB
None
512 MB
Write Back
Enabled
Enabled
All, but not keyboard
Disabled
Auto
30/sec
½ sec
0800068F9DB5
Disabled
Enabled
0800068F9E69
Disabled
Enabled
Auto
640 KB
515072 KB
23
W-NXS AND CP-NXS
NXS / Notes
You can also set time and date from
AX
a Niagara or Niagara connection.
1024 MB (if CompactFlash model),
or
nnnn MB reflects hard drive size
(where Type = Auto)
Default (None)
None
Default (Write Back)
Defaults
Defaults
Defaults
(Read Only)
74-4059—01