Table of Contents
Advertisement
STORAGE AND TIPS FOR USING THE RC
How to insert the batteries
1. Unscrew the screw on the battery cover.
2. Gently press down on the battery cover and push in
the direction of the arrow to remove, as shown.
3. Remove the old batteries.
4. Replace with two 7# dry cell batteries (AAA 1.5V).
Ensure that "+" and "-" polarity is correctly positioned.
5. Close the battery cover on the remote control.
6. Put back the screw on the remote control.
How to remove the batteries
Unscrew the screw and remove the battery cover in the
direction of the arrow.
Press the positive pole of the battery softly with your
fingers, then draw the batteries out of the compartment.
All this should be done by adults, children are forbidden
to remove the batteries from the remote control in
order to avoid danger of swallow.
Disposal of the batteries
Please discard the batteries as sorted municipal waste at
the accessible collection point.
To operate the air conditioner, point the remote control
at the signal receptor.
The remote control will operate the air conditioner at a
distance of up to 7m.
Precautions
• When replacing the batteries, do not use new
batteries with old batteries, or different types of batteries as this may cause the remote control to
malfunction.
• If you do not expect to use the remote control for some time, take the batteries out to prevent leakage
of battery acid in the remote control.
• Operate the remote control within effective range.
• Keep the remote control at least 1 meter from any TV set or hi-fi equipment.
• If the remote control does not work normally, take the batteries out and reinstall after 30 seconds. If it
still does not work install new batteries.
• To operate the main unit by remote control, point the remote control at the receiving device on the
main unit, to ensure receiving sensibility.
• To send a message from remote control, the symbol
message, the main unit will emit a beep.
Emergency Operation
If your remote control is lost or damaged, you can use the AUTO/STOP key, in which case the unit will
run in auto mode and you cannot change the preset temperature and fan speed.
Operate as below:
START: In stop status, press this key to switch the air conditioner to 6th Sense. Depending on the indoor
temperature, the microcomputer will automatically select the mode (COOL, HEAT or FAN) for your
comfort.
STOP: In on status, press this key to stop the air conditioner.
2
3
will flash for 1 second. On receipt of the
31
1
4
key switch
Advertisement
Table of Contents
