Whirlpool AMD 061 Instructions For Use Manual page 8

OPERATION INSTRUCTIONS
Operating modes
1. Selecting mode
Each time the MODE button is pressed, operating mode changes in the
following sequence:
COOLING DRY
2. "FAN" mode
Each time the "FAN" button is pressed, the fan speed changes in the
following sequence:
AUTO HIGH
IMPORTANT:
• In "FAN ONLY" mode, only "High" and "Low" are available.
• In "DRY" mode, airflow is set at "Low" automatically, "FAN" button
is ineffective in this case.
3. Setting temperature
Press once to raise temperature setting by 1°C
Press once to lower temperature setting by 1°C
Temperature range for presetting:
COOLING
DRY
FAN ONLY
4. Turning on
Press the button. The RUN indicator will light up on the indoor unit
when the signal is received.
Jet, 6th sense, DRY, TIMER ON and TIMER OFF operating modes
will be specified in the following pages.
IMPORTANT:
• The unit will often not respond immediately when operating mode
is changed during operation. Wait for 3 minutes.
• Allow 3 minutes to elapse before restarting the appliance.
Cooling mode
If you want to cool the room, you can operate the appliance as follows:
1. Press the MODE button and select cooling mode.
2. Press the FAN button to select the fan speed.
3. You also can set the appropriate temperature by using the temperature button.
4. When the above steps have been completed, press the ON/OFF button to make the appliance run in cooling
mode.
5. You can adjust the fan direction by pressing the SWING button; press once to start, again to stop.
Dry mode
This function dehumidifies the room.
1. Press the MODE button and select dry mode.
2. You can set the appropriate temperature by using the temperature button.
3. Press the ON/OFF button to make the appliance run in dry mode.
4. You can adjust the fan direction by pressing the SWING button; press
once to start, again to stop.
Note:
• The dry mode cannot be used to cool the room.
• A hot air outlet hose is required in Dry mode.
• In dry mode, fan speed is preset by the appliance, so the fan button
is not applicable.
• In heater mode,
26
FAN ONLY HEATER
LOW
18°C ~ 32°C
room temperature ± 2°C
unable to set
and are not applicable.
2
3
1
4
1