working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
NOTE:
This procedure is applicable only for computers shipped with non-touchscreen displays.
1. Route the display cable along the routing guides, starting from the bottom of the display (near the hinges).
2. Route the rest of the display cable along the routing guides on the left side of the display back-cover and antenna assembly.
3. Slide the camera cable into the connector on the camera module to secure the cable.
Post-requisites
1. Replace the
display
hinges.
2. Replace the
display
panel.
3. Replace the
display
bezel.
4. Replace the
display
assembly.
5. Replace the
wireless
card.
6. Replace the
base
cover.
7. Replace the
optical drive
Display back-cover and antenna assembly
Removing the display back-cover and antenna assembly
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Prerequisites
1. Remove the
optical drive
2. Remove the
base
cover.
3. Remove the
wireless
card.
4. Remove the
display
assembly.
5. Remove the
display
bezel.
72
Removing and installing components
(applicable only to computers shipped with optical drive).
computer. After working inside your computer, follow the instructions in
(applicable only to computers shipped with optical drive).
After