Post-requisites
1. Replace the
display
bezel.
2. Replace the
display
assembly.
3. Replace the
wireless
card.
4. Replace the
base
cover.
5. Replace the
optical drive
Display panel
Removing the display panel
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Prerequisites
1. Remove the
optical drive
2. Remove the
base
cover.
3. Remove the
wireless
card.
4. Remove the
display
assembly.
5. Remove the
display
bezel.
Procedure
NOTE:
This procedure is applicable only for computers shipped with non-touchscreen displays.
1. Remove the four screws (M2x2) that secure the display panel to the display back-cover and antenna assembly.
2. Lift the display panel and turn it over.
3. Peel the tape adhering the display cable to the back of the display panel.
4. Lift the latch and disconnect the display cable from the display-panel cable connector.
5. Lift the display panel away from the display back-cover and antenna assembly.
(applicable only to computers shipped with optical drive).
computer. After working inside your computer, follow the instructions in
(applicable only to computers shipped with optical drive).
Removing and installing components
After
67