Table of Contents
Advertisement
3. Connect the fan cable to the system board.
4. Route the display cable through the routing guides on the fan.
5. Connect the display cable to its connector on system board and close the latch to secure the cable.
NOTE:
The following steps are applicable only to computers that are shipped with optical drive.
6. Press down on the latch to connect the optical-drive connector-board cable to the optical-drive connector board.
7. Press down on the latch to connect the optical-drive connector-board cable to the system board.
Post-requisites
1. Replace the
base
cover.
2. Replace the
optical drive
(applicable only to computers shipped with optical drive).
Removing and installing components
31
Advertisement
Table of Contents
