Table of Contents
Advertisement
NOTE:
The following steps are applicable only if you want to further remove any other component from your
computer.
6. Peel the tape that adheres the battery cable to the connector and disconnect the battery cable from the system board.
7. Press and hold the power button for five seconds to ground the computer and drain the flea power.
Procedure for the computers that are shipped with optical drive
1. Loosen the three captive screws on the base cover.
2. Remove the screw (M2x4) that secures the base cover to the palm-rest and keyboard assembly.
3. Remove the two screws (M2x2) that secure the base cover to the palm-rest and keyboard assembly.
4. Remove the six screws (M2.5x7) that secure the base cover to the palm-rest and keyboard assembly.
14
Removing and installing components
Advertisement
Table of Contents
