Citizen CL-S521 User Manual page 36

2
Printer Operation
Mode Settings
®
[Zebra Emulation]
Top Menu
After Print
Interface
* Effective only when the optional unit is attached.
Sub Menu Default
AutoConfigure On
Function Select Tear
Cutter Action* Backfeed
Paper Position 0.00IN
0.00mm
Mode/Repeat Key Disabled
RS-232C Baud 9600
RS-232C Parity None
RS-232C Length 8 bits
RS-232C Stop bit 1 bit
RS-232C X-ON Yes
IEEE1284 ON
Menu Remarks
On Optional auto configure
Off On .... Auto configure effective.
If a peeler unit or auto-cutter is
installed, each mode is automatically
set regardless of the "function select"
setting.
Off ... Auto configure ineffective.
When a peeler unit or auto-cutter is
installed but has not been started, it is
off and the operation is selected by
"Function select".
Off Selects the type of options installed and
Tear adjusts the "paper stop" position accordingly.
Peel On* For example, the position where the label
Cut On* stops in "Tear" mode is different to that in
"Peel On" mode.
Backfeed Cutter operating method setting
Through Backfeed: it feeds back after each cutting
operation.
Through: when the number copied = n, the
back end of sheet 1 to n-1 passes through,
and the back end of the final page that is a
single sheet is copied and fed back.
Peel/Cut/Tear Off The stop position can be fine tuned using
0.00 to 2.00 IN this menu setting. The general stop position
0.0 to 50.8mm is selected depending on the "Function"
Peel/Cut/Tear On selected above.
-1.00 to 1.00 IN
-25.4 to 25.4mm
LabelSet Repeat method selection
LastOne LabelSet:
Disabled Reissues multiple labels.
LastOne:
Issues only the final page.
In count case, it issues only 1 label while
continuing.
Disabled:
Makes the repeat key invalid.
1 15200 Sets the baud rate of the serial interface.
57600 • Interface related settings are effective
38400 after the power is turned on again.
19200
9600
4800
2400
None Sets the communication parity of the serial
Odd interface.
Even
8 bits Sets the character length of the serial
7 bits interface.
1 bit Sets the stop bit of the serial interface.
2 bits
Yes Selects the X-ON flow control of the serial
No interface.
ON Enable or disables the 'enhanced' features of
OFF the IEEE1284 parallel interface.
36