Citizen CL-S521 User Manual page 33

Top Menu Sub Menu
Emulation Select
Emulation Auto
Detect
After Print AutoConfigure
Function Select
Cutter Action*
Paper Position
Mode/Repeat Key
Interface RS-232C Baud
RS-232C Parity
RS-232C Length
* Effective only when the optional unit is attached.
Default Menu
DM4 DMI
DM4
DPP
ZPI2
On On
Off
Full Auto
On On
Off
Tear Off
Tear
Peel On*
Cut On*
Backfeed Backfeed
Through
0.00IN Peel/Cut/Tear Off
0.00mm 0.00 to 2.00 IN
0.0 to 50.8mm
Peel/Cut/Tear On
-1.00 to 1.00 IN
-25.4 to 25.4mm
Disabled LabelSet
LastOne
Disabled
9600 1 15200
57600
38400
19200
9600
4800
2400
None None
Odd
Even
8 bits 8 bits
7 bits
33
Printer Operation
Mode Settings
[Datamax
Remarks
Selects DataMax ® /Zebra ® compatibility
DMI: DataMax ® IClass
DM4: DataMax ® 400 like
DPP: DataMax ® Prodigy Plus ®
®
ZPI2: Zebra Emulation
Selects the detection of Datamax
Zebra ® emulation.
Optional auto configure
On .... Auto configure effective.
If a peeler unit or auto-cutter is
installed, each mode is automatically
set regardless of the "function select"
setting.
Off ... Auto configure ineffective.
When a peeler unit or auto-cutter is
installed but has not been started, it is
off and the operation is selected by
"Function select".
Selects the type of options installed and
adjusts the "paper stop" position accordingly.
For example, the position where the label
stops in "Tear" mode is different to that in
"Peel On" mode.
Cutter operating method setting
Backfeed: it feeds back after each cutting
operation.
Through: when the number copied = n, the
back end of sheet 1 to n-1 passes through,
and the back end of the final page that is a
single sheet is copied and fed back.
The stop position can be fine tuned using
this menu setting. The general stop position
is selected depending on the "Function"
selected above.
Repeat method selection
LabelSet:
Reissues multiple labels.
LastOne:
Issues only the final page.
In count case, it issues only 1 label while
continuing.
Disabled:
Makes the repeat key invalid.
Sets the baud rate of the serial interface.
• Interface related settings are effective
after the power is turned on again.
Sets the communication parity of the serial
interface.
Sets the character length of the serial
interface.
®
Emulation]
®
and