Fujitsu ETERNUS LT260 User Manual page 14

Chapter 1 Overview
1.2 References for Setup
Refer
1.2.2.2 Fibre Channel Connection (FC-AL Connection) for Linux
The following procedure explains how to connect the LT260 to a Linux server with an FC-AL connection (direct
connection to a server).
Workflow
Refer
IMPORTANT
Refer
FUJITSU Storage ETERNUS LT260 Tape Library User's Guide -Server Connection-
Setting Backup Software
Apply patches, make settings for the robot driver, and set up the backup software.
•
Backup software used
-
NetBackup
•
"4.1 NetBackup" (page 38)
-
NetWorker
•
"4.2 NetWorker" (page 41)
-
IBM Spectrum Protect (IBM Tivoli Storage Manager)
•
"4.3 IBM Spectrum Protect" (page 43)
-
NetVault
•
"4.5 NetVault" (page 45)
Making a Check before Starting the Procedure
Check the environment (operating system, backup software, and HBAs) of the server to be
connected to the LT260.
-
"1.1 Operating Environment" (page 8)
Setting the LT260
Perform the settings for the LT260.
Change the topology setting to "Fabric (N/F)" or "Loop (L)". Set fixed values for the link speed
and the Loop ID/ALPA.
-
"Chapter 2 Setting the LT260" (page 22)
-
"2.2 Settings for Fibre Channel Connections" (page 22)
-
"2.2.1 Setting the Link Speed" (page 22)
-
"2.2.2 Setting the Topology and the Loop ID (for Direct Host Connections)" (page 23)
Copyright 2019 FUJITSU LIMITED
14
P3AM-8812-07ENZ0