Raider RD-ETC25 User Manual page 12

12 www.raider.bg
the tool unattended when it is plugged into an
electrical outlet. Turn off the tool, and unplug it
from its electrical outlet before leaving.
2.18. Never allow the blade to run dry. Cutting
with a dry blade will cause excessive wear and
possible damage to the blade and motor.
2.19. When transporting the machine, use
only transportation devices and do never use
guards for handling or transportation.
3. ASSEMBLY INSTRUCTIONS
WARNING! Never connect the plug to power
source outlet until all installations and adjustments
are completed and you have read and understood
the safety and operational instructions.
Check that the power supply and electrical
outlet used are in accordance with your wet saw.
Have a look at the rating plate on the wet saw.
Any changes should always be carried out by a
qualified electrician.
WARNING! This machine must be earthed. If
not properly earthed this machine can cause an
electrical shock. Be sure that the power supply
outlet is earthed. If there is any doubt, have it
checked by a qualified electrician.
4. Operating Instructions
Read and understand the following items
about your tile cutter before attempting to use the
machine.
Fig.1
• Adjust the required tool position, then tighten
all the adjusting knobs, fence bolts and mitre
gauge bolts.
• Turn on the main switch and allow your tool
to reach the maximum speed before commencing
cutting.
• Hold the workpiece firmly against the work
table and fence, then feed machine smoothly and
evently to the workpiece.
• Cutting actions tends to slow the blade
down. Pressure should therefore be occasionally
released to allow the blade to regain the full
speed.
Warning! Do not attempt topick up an off-cut
or to remove the holding workpiece before the
cutting blade has completely stopped. If holding
the workpiece by hand take extreme care and
ensure hand is kept away from the cutting blade.
● Connect the machine to mains by using an
approved RCD circuit breaker.
● Make sure you have marked your tile for
cutting.
WARNING! Do not allow your hands or fingers
to protrude over the notches at the back edge of
the sliding table. The blade will enter this space
during the cutting operation.
● Carefully follow your working line adjusting
tile cutting position if required.
● Never cut dry. Be sure the blade remains
wet during cutting operation. Frequently check
the water level in the water tray and add water as
often as necessary. Make sure the pump is well
below the water level.
● If the motor slows down, slow down your
feed rate or pull the tile smoothly back from the
blade.
● Wipe clean top with sponge during use to
reduce build up of debris. Always ensure the
machine is switched off when carrying out this
action.
● Stop the machine by using the on/off switch.
Allow the blade to come to a stop on its own.
Do not manually stop the blade by grabbing it or
holding an object against it.
WARNING! Do not attempt to pick up an off-
cut or to remove the holding tile before the cutting
blade has completely stopped.
● Remove the plug from power supply after
use. Empty the water tray, clean the machine and
pump. Lock the sliding table before maintenance,
transportation or storage.
5. Filling the Water
● Fill the water tray with clean water. Do not
add chemicals or detergents to the water. Make
sure the pump is well below the water level.
● Water can be added or refilled as needed
during the operation of the machine.
6. Straight Cutting
● Loosen the screw knob of the mitre gauge.
● Fit the mitre gauge onto the left side fence at
the back edge of the table.
● Set the mitre gauge to the desired size using
the embossed ruler guide.
● Relock the screw knob.
● Position the tile against the fence of the
table and against the mitre gauge when cutting.
7. Changing the Blade
● WARNING! To avoid injury from accidental
starting, always turn the switch off "O" and
remove the power plug from the power source
before changing the blade.