Table of Contents
Advertisement
HPT370/372/372A Red Hat Linux Installation Guide
[root@tmp]#
Note
If an old version is installed on your system you will be prompted to choose whether to
overwrite existing files or not. To continue the installation, type in " Y" .
Running the Management Software
You must log on as root to run the management software.
To run the software from a console window, you can just type in " hptraid" to start it. If
you do not want to block the console, type in " hptraid&" .
If you are using GNOME or KDE, you can also run it from the menu bar:
On KDE, you can start it by choosing " Menus (menu-bar)->Applications->HighPoint
ATA RAID Management Software" .
On GNOME, you can start it by choosing " KDE menus->GNOME->Applications->
HighPoint ATA RAID Management Software" .
7 Uninstalling
Uninstalling the Driver
You can only uninstall the driver when your system is not booting from devices attached
to HPT37x controller. Just remove the lines you added to /etc/modules.conf and
/etc/fstab.
Uninstalling the Management Software
Before you uninstall the software, you must log on as root. Then you can use the
command " hptinstall.sh – u" to uninstall the software.
[root@tmp]# hptinstall.sh -u
Are you sure to uninstall HighPoint ATA RAID Management Software?(Y/N)y
Stopping hptsvr daemon:
Uninstall finished!
[root@tmp]#
[ OK ]
- 14 -
Advertisement
Table of Contents
