Monitoring The Driver; Installing Raid Management Software; Troubleshooting - HighPoint SSD7540 Installation Manual

SSD7540 Linux CentOS8.2 Installation Guide
j. Follow the prompts to complete the driver installation.
k. After the installation is complete, you can perform a system update operation.

3 Monitoring the Driver

Once the driver is running, you can monitor it through the Linux proc file system support.
There is a special file under /proc/scsi/hptnvme /. Through this file you can view driver
status and send control commands to the driver.
Note
The file name is the SCSI host number allocated by OS. If you have no other SCSI cards
installed, it will be 0. In the following sections, we will use x to represent this number.
Using the following command to show driver status:
# cat /proc/scsi/hptnvme/x
This command will show the driver version number, physical device list and logical device
list.

4 Installing RAID Management Software

HighPoint RAID Management Software is used to configure and keep track of your hard
disks and RAID arrays attached to SSD7540 controller.
Please refer to HighPoint RAID Management Software documents for more information.

5 Troubleshooting

Error1： If you fail to install the driver or restart the system after installing the driver, the
driver cannot be used. Please follow the steps below.
a. After entering the system, use the command to uninstall the original driver:
# hptuninhptnvme
b. Connect to the network and install the following package files:
# yum install elfutils-libelf-devel
- 9 -