Panel Mount Installation Steps - Emerson RXi Quick Start Manual

Quick Start Guide
GFK-3073B
4.1.1

Panel Mount Installation Steps

1. Verify that the gasket is present and properly seated in the bezel channel located on the sides of the
unit
2. Carefully insert the Web Panel into the mounting panel cutout
Figure 4.2: Panel Install View
3. Insert the hook of the mounting bracket into the mounting hole as displayed in the following figure.
4. Tighten all mounting brackets by hand until the gasket seal contacts the mounting surface uniformly.
5. In a cross pattern around the monitor tighten all mounting clip screws to a torque of 13-13.9 in-lbs (15-16
kgf-cm) making sure not to overtighten the bracket.
Figure 4.3: Mounting Bracket Insertion
Mounting Information
Section 4
Nov 2019
22