Check The Port Statistics - Cisco Catalyst Express 500-24LC User Manual

Check the Port Statistics

Speed
The operating speed of the port. The speed can be 10, 100, or 1000 Mbps. This is
configured from Configure > Port Settings.
Duplex The duplex state of the port. The duplex mode can be full or half duplex. This is
configured from Configure > Port Settings.
Auto-MDIX
The state of the automatic medium-dependent interface crossover (auto-MDIX) feature.
The feature can be enabled or disabled. This is configured from Configure > Port
Settings.
PoE
The PoE state of the port:
Off—A PoE device is not connected to the port.
•
• Admin Off—The port is set to never provide power to a connected PoE device.
Error-Disabled—The port is disabled due to a misconfiguration or violation on the
•
switch.
On—A PoE device is connected to the port, and this port can provide it with power.
•
• Power Deny—The power budget is allocated to other ports, and this port cannot
provide power to a connected PoE device.
If the port is supplying power to a device, the state includes the number of watts
that is allocated to the port.
Note

Check the Port Statistics

User Guide for the Catalyst Express 500 Switches
4-18
This status is available only on PoE ports.
Use the Port Statistics window to display the statistics for data sent from and
received by the switch ports since the switch was last powered on, was restarted,
or since the statistics were last cleared.
The types of port statistics collected and displayed are grouped under these tabs
on the Port Statistics window:
Overview Tab, page 4-19
•
• Transmit Detail Tab, page 4-20
Receive Detail Tab, page 4-21
•
Chapter 4 Monitoring
OL-8122-01