Warnings - Cisco Catalyst Express 500-24LC User Manual

Install the Switch

Warnings

Warning
Warning
Warning
Warning
Warning
Warning
User Guide for the Catalyst Express 500 Switches
2-6
These warnings are translated into several languages in the Regulatory
Compliance and Safety Information for the Catalyst Express 500 Switches
document that shipped with the switch. Review these warnings before you power
or install the switch.
To prevent the switch from overheating, do not operate it in an area that
exceeds the maximum recommended ambient temperature of 113°F (45°C). To
prevent airflow restriction, allow at least 3 inches (7.6 cm) of clearance around
the ventilation openings. Statement 17B
Before working on equipment that is connected to power lines, remove jewelry
(including rings, necklaces, and watches). Metal objects will heat up when
connected to power and ground and can cause serious burns or weld the metal
object to the terminals. Statement 43
Do not stack the chassis on any other equipment. If the chassis falls, it can
cause severe bodily injury and equipment damage. Statement 48
Attach only the Cisco RPS (model PWR675-AC-RPS-N1=) to the RPS receptacle.
Statement 100C
Ethernet cables must be shielded when used in a central office environment.
Statement 171
If a redundant power system (RPS) is not connected to the switch, install an RPS
connector cover on the back of the switch. Statement 265
Chapter 2 Setup and Installation
OL-8122-01