GE Power Break II Installation Instructions Manual page 10

Power Break® II Circuit Breakers
Draw-Out Breaker Installation
frequent intervals.
may not be sufficient and additional precautions
may be necessary to protect the equipment.
Lubrication
All the areas subject to friction are liberally coated at
the factory with Mobil 28 red grease.
surfaces, the breaker power screw,
pin are cleaned during
primary disconnect contact surfaces, the threads of the
nut or screw, and the interlock pin with Mobil 28.
In this case, this procedure
If the contact
and the interlock
maintenance, coat the
6