Schaudt LAS 1218 BUS Operating And Installation Instructions page 15

2.3.1.3
Deliverables
8100532 BA / EN
Operating and Installation - Battery Charger LAS 1218 BUS
 Secure the battery sensor cable at suitable places (particularly near the
connector on the LAS 1218 BUS battery charger to prevent the 2-pin
connector from coming loose)
Direct connection to leisure area and starter battery
For this type of connection, there is a direct connection between the LAS
1218 BUS battery charger and the two motorhome batteries (or also only
one battery, e.g. for a caravan).
The following parts are supplied under part number 999.086 for this applica-
tion:
7
5
Fig. 6 Parts for general upgrades
Pos. Qty
1 1
2 7
3 3
4 3
5 2
6 1
7 1
The connector set (Pos. 2 to 6) is required to connect the LAS 1218 BUS
battery charger to up to two batteries.
The length of the line to the starter battery may not exceed 4 m (supply
Y
and return lines together) for a cable cross-section of 2.5mm (see also
table on Page 10).
Date: 21.11.2018
6
2
Name
LAS 1218 BUS battery charger
Flat push-on contacts, 6.3 x 0.8 (blue)
Ring terminal, 1 ... 2.5 mm
Ring terminal, 1 ... 2.5 mm
Fuse holder for flat vehicle fuse
Flat vehicle fuse, 20A
Flat vehicle fuse, 10 A
4
3
1
2
M6
2
M8
15