Schaudt LAS 1218 BUS Operating And Installation Instructions page 11

Fuse protection
8100532 BA / EN
Operating and Installation - Battery Charger LAS 1218 BUS
Fig. 2 Parts required for LAS 1218 BUS as auxiliary charger to EBLs
Pos. Qty
1 1
2 1*
3 1*
* Pos. 2 and 3 as an alternative depending on electroblock to be connected
The connector cable (Pos. 2 or 3) is required to connect the LAS 1218 BUS
battery charger to the electroblock.
An additional fuse is not required as there is already one integrated in the
electroblock. You only have to check if the fuse is fitted and if it complies
with the fuse rating on the label.
The battery charger is connected to the electroblock with a 2-pin charger ca-
ble. Other lengths are available on request.
A connection to the starter battery is not required because the electroblock
already has the start battery recharge module.
Date: 21.11.2018
3
2
1
Name
LAS 1218 BUS battery charger, isolated ground
or WAGO connector (optional)
Connector cable, 1.7 m with Minifit connector
Connector cable, 1.7 m with MNL connector
11