Jconcepts BJ4 Worlds Edition Manual page 8

STEP 6
FINAL DIFF ASSEMBLY:
1. SLIDE ONE OUTDRIVE SHIM AND ONE
3/8 x 5/8 BEARING ONTO EACH SIDE
OF THE DIFF ASSEMBLY.
SCALE: 1:1
3/8 x 5/8 BEARING
x 4
CENTER CVD BAG
CVD COUPLING
x 2
CENTER CVD INPUT SHAFT
x 2
STEP 7
CENTER CVD ASSEMBLY:
1. SPREAD A SMALL AMOUNT OF BLACK GREASE ON THE OUTSIDE OF THE CVD COUPLING AND INSERT THE
COUPLING INTO THE AXLE AS SHOWN.
2. SPREAD A SMALL AMOUNT OF BLACK GREASE ON THE ROUND PORTION OF THE AXLE AND INSERT INTO THE
CVD BONE, ALIGNING THE CROSS HOLES.
3. INSERT THE CROSS PIN, MAKING SURE IT IS EVENLY SPACED ON BOTH SIDES OF THE CVD BONE.
4. APPLY A SMALL AMOUNT OF MIP THREAD LOCKING COMPOUND TO THE SET SCREW. ANGLE AND TURN
THE CVD SO THE SET SCREW CAN BE SCREWED IN WITH AN ALLEN WRENCH.
5. REPEAT THIS PROCEDURE FOR BOTH FRONT AND REAR CENTER CVD'S.
CVD CROSS PIN
SOLID
OUTDRIVE SHIMS,
VERY IMPORTANT
CENTER CVD COMPONENTS
CVD CROSS PIN
CVD SET SCREW
x 2
x 2
3/8 x 5/8 BEARING
CENTER CVD BONE "REAR"
x 1
CENTER CVD BONE "FRONT"
x 1
APPLY A SMALL AMOUNT
OF BLACK GREASE
APPLY A SMALL AMOUNT OF
THREAD LOCKING COMPOUND
PAGE 7