Table of Contents
Advertisement
PCM-D10
4-18. Sine Wave
The audio-related (headphone, speaker output system) can be
checked.
Procedure:
1. Enter the test mode.
(Refer to "1. SETTING THE TEST MODE" on page 51)
2. Press the [
DPC]/[ A-B
v
Test mode menu screen
Erase IPL2
Initialize Menu
Factory Shipment
Key Check
Mic Check
BT
NFC
Audio Loop
Sine Wave
3. Press [
] button to display the audio output screen is displayed.
N
(Displayed characters/values in the following fi gure are exam-
ple)
Screen display
VOL : 15
Infinity zero
OUT : HP
4. Check the operation of each output.
Button input settings under this mode of operation:
[VOL +]
: Volume up
[VOL –]
: Volume down
[
]
: Audio output playback/pause change
N
(PLAY/PAUSE)
[
STOP]
: Audio output stop
x
[
]/[
] : Output contents change
.
>
(Infi nity zero/1 kHz/1 kHz (L-ch)/1 kHz (R-ch))
[OPTION] : Output point change (HP/SP)
5. Press the [ BACK/ HOME] button, return to test mode menu
screen.
4-19. INT Mic Check
Note: Not used for the servicing.
4-20. Setting Dest
The destination setting can be executed.
Refer to "DESTINATION SETTING METHOD" on page 8 for this
item.
4-21. Debug Mode
Note: Not used for the servicing.
4-22. Chg Info
Note: Not used for the servicing.
4-23. To Normal Mode
Note: Not used for the servicing.
If you accidentally returned the normal mode by entering this mode,
refer to "1. SETTING THE TEST MODE" on page 51 to enter test
mode again, and then execute "4-12. Factory Shipment" on page 55.
57
] buttons to select the "Sine Wave".
V
Volume
Output contents
Output point
Sony CONFIDENTIAL
For Authorized Servicer
SYS SET
Advertisement
Table of Contents
