Main Board - Sony PCM-D10 Service Manual

PCM-D10

2-23. MAIN BOARD

Note 1: When the MAIN board is replaced, make sure to refer to
the following pages and perform each procedure.
DESTINATION SETTING METHOD (page 8)
BLUETOOTH CONNECTION CHECKING METHOD (page 10)
XLR/TRS JACK CHECKING METHOD (page 15)
LINE OUT JACK CHECKING METHOD (page 19)
• Pasting position of the insulating sheet PWB
insulating
sheet PWB
insulating
sheet PWB
• How to install the flexible flat cable
Insert the flexible flat cable straight into the interior.
There is a possibility that using this unit without the
connector correctly installed will damage it.
OK
Insert straight into
the interior.
flexible flat
cable
connector
NG
Insert at a slant.
flexible flat
cable
connector
43
MAIN board
W
B
B
R
5 insulating sheet PWB
6 MAIN board
NG
Insert only part way.
flexible flat
cable
connector
• Installation direction of the flexible flat cable (12P)
MAIN
board
[blue]
5 insulating
1 flexible flat cable (12P)
sheet PWB
(CN401)
terminal side
terminal side
4 flat cable HP (4P)
(See Fig. F)
Note 2: When the MAIN board is replaced,
4 flat cable HP (4P)
(See Note 1)
(See Fig. F)
Note 2: When the MAIN board is replaced,
• Flat cable HP (4P) setting
< Fig. F >
flat cable HP (4P)
flat cable HP (4P)
Sony CONFIDENTIAL
For Authorized Servicer
MIC_JACK
board
[white]
2 flexible flat cable (10P)
(CN651)
the flat cable HP (4P) is included
with the MAIN board.
3 Remove four solders of
the flat cable HP (4P).
3 Remove four solders of
the flat cable HP (4P).
the flat cable HP (4P) is included
with the MAIN board.
MAIN board
[red]
[blue]
[red]
[blue]
SYS SET