Table of Contents
Advertisement
PCM-D10
XLR/TRS JACK CHECKING METHOD
When the following target part replaced with new part, follow the
procedure in this section to check the XLR/TRS jack.
Target part:
Complete MAIN board
Complete SW board
SVX XLR assy (part including XLR board)
Beforehand preparation:
Prepare the following equipment etc.
•
External microphone with phantom power support (commercial
products) (2)
If 2 units can not be prepared, even 1 unit can do work.
•
Headphone or earphone
•
Size AA batteries (4)
Open the battery lid on the rear side of main unit, install the four
size AA batteries.
XLR/TRS jack checking procedure:
1. Turn the power on by turning ON of the [POWER] switch on the
left side of main unit.
2. Set the [+48V] (phantom power switch) on the front of the main
unit to the "OFF" position.
15
3. Connect the external microphone prepared in advance to the
XLR/TRS jack of this unit.
Note 1: If 2 external microphones can be prepared, connect to both XLR/
TRS jacks of L/R.
If only 1 external microphone can be prepared, fi rst connect an ex-
ternal microphone to the L side and record. After completing the
procedure up to step 22, work from this procedure again, connect
the external microphone to the R side and record. (At this time,
nothing is connected to the L side)
When connecting 2 external microphones:
External microphone
(commercial products)
L
R
When connecting external microphones 1 at a time (first time):
L
When connecting external microphones 1 at a time (second time):
External microphone
(commercial products)
R
4. Set the [INPUT] switch on the front of the main unit to the
"XLR/TRS" position.
Sony CONFIDENTIAL
For Authorized Servicer
External microphone
(commercial products)
External microphone
(commercial products)
– Continued on next page –
SYS SET
Advertisement
Table of Contents
