Table of Contents
Advertisement
PCM-D10
2-10. MIC_JACK BOARD
2 chassis (jack)
Note 1: When installing the chassis (jack),
align the two ribs and two holes.
3 Remove two solder of the MIC
SW board (L) wire. [blue/gray]
3 Remove two solder of the MIC
SW board (R) wire. [brown/gray]
4 flexible flat cable
(12P) (CN955)
3 Remove two solder
of the MIC (R) wire.
[red/gold]
bottom side
7 boss
32
hole
hole
rib
rib
terminal
side
front side
MIC_JACK board
hole
6 Lift up the MIC_JACK
board in the direction
of the arrow.
How to install the flexible flat cable
Insert the flexible flat cable straight into the interior.
There is a possibility that using this unit without the
1 screw
connector correctly installed will damage it.
(Z1.7
4.5)
Insert straight into the interior.
flexible flat
cable
colored line
connector
5 screw (M1.4)
(L = 2.5 mm)
Insert at a slant.
flexible flat
top side
cable
colored line
connector
3 Remove two solder
of the MIC (L) wire.
[red/gold]
MIC_JACK board
top side
MIC (R)
wire [red]
MIC SW board
MIC (R)
(R) wire [gray]
wire [gold]
MIC SW board
(R) wire [brown]
9 MIC_JACK board
hole
Sony CONFIDENTIAL
For Authorized Servicer
OK
NG
NG
Insert only part way.
flexible flat
cable
colored line
connector
Press the MIC wire into the slit
of MIC_JACK board.
MIC SW board
(L) wire [gray]
MIC SW board
(L) wire [blue]
Note 2: When installing the MIC_JACK
board, align the jack and hole.
jack
8 Remove the MIC_JACK board
in the direction of the arrow.
MIC (L)
wire [red]
MIC (L)
wire [gold]
SYS SET
Advertisement
Table of Contents
