Hp_Line_Jack Board - Sony PCM-D10 Service Manual

PCM-D10

2-12. HP_LINE_JACK BOARD

Note 1: When the HP_LINE_JACK board is replaced, make sure to
refer to "LINE OUT JACK CHECKING METHOD" on page 19,
and check the LINE OUT jack.
1 Remove eight solder of
the flat cable HP (4P).
bottom side
3 Lift up the HP_LINE_JACK
board in the direction of the
arrow.
34
2 screw
(Z1.7 4.5)
top side
front side
flat cable HP
(4P)
flat cable HP
(4P)
HP_LINE_JACK board
HP_LINE_JACK board
top side
5 HP_LINE_JACK board
Note 2: When installing the HP_LINE_JACK board,
align the two jacks and two holes.
jack
4 Remove the HP_LINE_JACK
board in the direction of the
arrow.
Sony CONFIDENTIAL
For Authorized Servicer
[red]
[blue]
[red]
[blue]
jack
hole
hole
SYS SET