Table of Contents
Advertisement
PCM-D10
2-28. SW_R BOARD
chassis (SD card) block
4 Lift up the SW_R board in
the direction of the arrow.
6 Remove the SW_R board in
the direction of the arrow.
5 boss
hole
groove
7 SW_R board
Note 2: When installing the SW_R board,
align the hole and groove with
the two bosses.
47
2 knob (hold)
Note 1: When installing the knob (hold),
1 claw
groove
slide switch
SW_R board
5 boss
align the groove and slide switch.
Turn over.
The SW_R board is
installed inside the
two ribs.
rib
SW_R board
8 chassis (SD card)
Sony CONFIDENTIAL
For Authorized Servicer
3 screw (M1.4)
(L = 2.5 mm)
OK
NG
The SW_R board is
installed over the
two ribs.
rib
SW_R board
SYS SET
Advertisement
Table of Contents
