Table of Contents
Advertisement
ET System electronic GmbH
Figure 4.3 Von、Voff
If Von-Delay parameter is set, the E-load will load, when the source voltage reached Von
and have delayed for Von-Delay time.
4.1.2 Source Type Selection Function
The E-load has the function of automatically detecting the type of source under test. But
in some special cases, the source loaded dosen't meet your expectations. you can set
the corresponding parameters manully according to your source type,and the E-load will
load it according to the type of source you selected.
In MENU page, select the SYSTEM item and press the key
to enter the parameter
setting page. Select the source type under test.
4.2 Configuration
In MENU page, select the item CONFIG and press the key
to enter the parameter
setting page, as shown below.
56
Advertisement
Table of Contents
