Table of Contents
Advertisement
commands on the PC to perform related operations on the E-load.
2.5 Rear Panel
The following picture is the rear panel for the ELP/DCH E-load.
Item
1
Cooling holes
0 to full-scale current, corresponding to 0-10V output, can be connected
2
to the oscilloscope
3
Hardware Power button
4
Power inlet ( AC 100~240V input)
5
LAN communication port
6
SENSE port for voltage sense compensation
7
DB9 communication interface, RS232/485
I/O interface connector, this I/O interface need to be powered by external
8
power
2.6 First turn-on checkout
The successful self-test process indicates that the E-load meets the factory standards and
ET System electronic GmbH
means E-load connecting to the PC, it is allowed to Send
Figure2.3 Rear panel
Description
16
Advertisement
Table of Contents
