Slot - NEC MultiSync P435 User Manual

SLOT

SLOT MENU
OPTION*
2
POWER CONTROL
POWER SUPPLY
POWER BUTTON
FORCE SHUTDOWN
RESET
Connection Status* 3
Power Status*
3
Module*
3
POWER SETTING
AUTO POWER UP
AUTO SHUTDOWN*
POWER SUPPLY OFF
DELAY
AUTO DISPLAY OFF
OFF WARNING
ADVANCED SETTING
CHANNEL SELECT
INTERFACE CAPABILITY
Configure settings for a connected Option Board.
Controls power to an Option Board.
Select [YES] then press SET on the remote control to power on the device.
Select [NO] then press SET on the remote control to power off the device.


NOTE: The option that is highlighted under [POWER SUPPLY] when you open the [POWER CONTROL]
menu indicates the current power status. If [YES] is highlighted, the power is on. If [NO] is
highlighted, the power is off.
Allows the same operation as the power button on the installed Option Board.
Press SET to force a shutdown of the device installed in the option slot.


NOTE: Please use this function only when the operating system cannot be shut down manually.
Press SET to force a shutdown and restart of the Option Board when it does not respond to shutdown
using the [POWER BUTTON] or [FORCE SHUTDOWN] function.


NOTE: • This function may corrupt data files on the Option Board or data files on a storage device
connected to an installed Option Board.

•
Please only use this function when [POWER BUTTON] and [FORCE SHUTDOWN] cannot be
carried out.
Shows the connection status of an Option Board. If the status is not "Connected" then a device is not
installed.
Shows the operating status of the installed Option Board.
Shows information about the installed Option Board.
The installed Option Board will be turned on automatically when the monitor power is turned on.
The installed Option Board is turned off when the monitor switches into standby mode.
4
When [OFF] is selected at [OPTION POWER], this sets the time delay after [AUTO SHUTDOWN] executed
until the power to the Option Board is turned off.
Allows the monitor to switch into the same status when the installed device is switched into standby or
power save mode.


NOTE: If you select [ENABLE], the monitor does not automatically power on when the Option Board
turns on.
Shows a warning, when shutting down the power to the Option Board, that the device should be turned off
from within the OS of the device. This message cannot be changed.
This function is available when [POWER SUPPLY] is [OFF].
Allows the monitor to show two video signals, DisplayPort and TMDS of the device installed in the option

slot.

When [AUTO] is selected, the screen display is set according to the specifications of the device installed in
the option slot.
Shows the signals supported by the device installed in the option slot.
English−97