Slot - NEC MultiSync C750Q User Manual

SLOT

SLOT MENU
ACTIVE SLOT
OPTION*
1
POWER CONTROL
POWER SUPPLY
POWER BUTTON
FORCE SHUTDOWN
RESET
Connection Status* 3
Power Status*
3
Module* 3
POWER SETTING
AUTO POWER UP
AUTO SHUTDOWN*
POWER SUPPLY OFF
DELAY
AUTO DISPLAY OFF
OFF WARNING
(Not adjustable)
COMPUTE MODULE
POWER CONTROL
POWER SUPPLY
POWER BUTTON
RESET
Connection Status
Power Status
Module
POWER SETTING
AUTO POWER UP
AUTO SHUTDOWN
POWER SUPPLY
OFF DELAY
AUTO DISPLAY OFF
OFF WARNING
ADVANCE SETTING
SHUTDOWN SIGNAL
IR SIGNAL
MONITOR CONTROL
WDT
START UP TIME
PERIOD TIME
This function is not available.
Configure settings for a connected Option Board.
This function is not available.
Allows the same operation as the power button on the installed Option Board.
Press [YES] to force a shutdown of the installed Option Board.


NOTE: Please use this function only when the operating system cannot be shut down manually.
This function is not available.
Shows the connection status of an Option Board. If the status is not "Connected" then a device is not
installed.
Shows the operating status of the installed Option Board.
This function is not available.
The installed Option Board will be turned on automatically when the monitor power is turned on.
* The installed Option Board is turned off when the monitor is switched into standby mode.
2, 4
When [OFF] is selected at [SLOT POWER], this sets the time delay after [AUTO SHUTDOWN] is executed
until the power to the Option Board is turned off.
Allows to the monitor switch into the same status when the installed device goes into standby or power
save mode.
This function is not available.
English−80