Ventilation Requirements; Mounting On Ceilings; Attaching Mounting Accessories; Noten - NEC MultiSync P435 User Manual

Ventilation Requirements

When mounting in an enclosed space or recessed area, leave adequate room between the monitor and the enclosure to allow
heat to disperse, as shown below.

NOTEN:

• Allow adequate ventilation or provide air conditioning around the monitor, so that heat can properly dissipate away
from the unit and the mounting equipment; especially when you use monitors in a multiple screen configuration.

• This monitor has internal temperature sensors.


If the monitor overheats, a "Caution" warning appears. If the "Caution" warning appears, stop using the unit, turn off
the power and allow it to cool.


If the monitor is used in an enclosed area or if the LCD panel is covered with a protective screen, and the
temperature is higher than the normal operating temperature, please turn the cooling fan to [ON] within the
[FAN CONTROL] menu within the OSD menu (see

Mounting on Ceilings

WARNINGN: Please refer to

Attaching Mounting Accessories

The monitor is designed for use with the VESA mounting system. Be careful to avoid tipping the monitor when attaching
accessories.
Mounting accessories can be attached with the monitor in the face down position. To avoid scratching the LCD panel, always
place a soft cloth, such as a blanket that is larger than the monitor's screen area, on the table before laying the monitor face
down. Make sure there is nothing on the table that can damage the monitor.
When using mounting accessories other than those that are NEC compliant and approved, they must comply with the VESA Flat
Display Mounting Interface Standard (FDMI).


NOTEN:
Prior to installation, place the monitor face down on a flat even surface that is larger than the monitor screen.
Use a sturdy table that can easily support the weight of the monitor.
"WARNING 8" and "WARNING
VESA Mounting Interface M6
≥100 mm
≥100 mm
<40 °C
page 100).
9".
300 mm
English−18
≥30 mm
300 mm