Troubleshooting; Fixture Cleaning - BoomToneDJ FLAT PAR Manual

7. Troubleshooting

Following are a few common problems that may occur during operation. Here are some
suggestions for easy troubleshooting:

The fixture does not work, no light
o Check the connection of power and main fuse.
o Measure the mains voltage on the main connector.

Not responding to DMX controller
o DMX LED should be on. If not, check DMX connectors, cables to see if link
properly.
o If the DMX LED is on and no response to the channel, check the address
settings and
o If you have intermittent DMX signal problems, check the pins on
connectors or on PCB of the fixture or the previous one.
o Try to use another DMX controller.
o Check if the DMX cables run near or run alongside to high voltage cables
that may cause damage or interference to DMX interface circuit.

Some fixtures don't respond to the easy controller
o You may have a break in the DMX cabling.
o Check the LED for the response of the master/ slave mode signal.

No response to the sound
o Make sure the fixture does not receive DMX signal.
o Check microphone to see if it is good by tapping the microphone.

8. Fixture Cleaning

The cleaning of internal must be carried out periodically to optimize light output.
Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surrounding can cause greater accumulation of dirt on the
fixture's optics.
 Clean with soft cloth using normal glass cleaning fluid.
 Always dry the parts carefully.
 Clean the external optics at least every 20 days. Clean the internal optics at least every
30/60 days
DMX polarity.
21