Mounting Location - Siemens QAW910 Manual

Notes on engineering and operation

Mounting location

4/6
Building Technologies
HVAC Products
The QAW910 must be mounted inside the house or building, on an inner wall about
1.5 m above the floor. To ensure that the QAW910 will acquire the room temperature
as accurately as possible, the following conditions must be observed:
• The QAW910 must not be mounted on an outer wall, not in niches, bookshelves, and
not behind doors or curtains
• Temperature acquisition must not be adversely affected by direct solar radiation, air
drafts, or other heat or refrigeration sources
• The permissible environmental conditions must be observed
• The QAW910 must not be exposed to dripping water
• For notes relating to engineering and mounting RF devices of the Siemens Synco
900 system, refer to Data Sheet CE1N2708en
• The base of the room unit must be fitted on a flat wall
• Minimum clearance at the bottom should be 60 mm to ensure that the battery
compartment is easily accessible
Room unit QAW910
SIEMENS
QAW910
Mode
CE1N2703en
11.07.2006