Troubleshooting Guide - EINHELL BG-CB 2041 T Original Operating Instructions

12. Troubleshooting guide

The table below contains a list of fault symptoms and explains what you can do to remedy the problem
if your equipment fails to work properly. If the problem still persists after working through the list, please
contact your nearest service workshop.
Fault
The equipment - Correct starting procedure not follo-
does not start wed
- Sooted or damp spark plug
- Incorrect carburetor setting
The equipment - Incorrect choke lever setting
starts but does - Soiled air fi lter
not develop its full - Incorrect carburetor setting
power
The engine does - Incorrect electrode gap on the
not run smoothly spark plug
- Incorrect carburetor setting
Engine smokes ex- - Incorrect fuel mix
cessively
- Incorrect carburetor setting
Saw chain is dry - No oil in the tank
- Vent in the oil tank cap is blocked
- Oil outlet blocked
Chain/guide bar - No oil in the tank
is hot - Vent in the oil tank cap is blocked
- Oil outlet is blocked
- Chain is blunt
- Chain is overtensioned
Chainsaw judders, - Chain is undertensioned
vibrates or does not - Chain is blunt
saw properly - Chain is worn
- Saw teeth point in the wrong direc-
tion
Anleitung_BG_CB_2041_T_SPK7.indb 30 Anleitung_BG_CB_2041_T_SPK7.indb 30
GB
Possible cause
- Follow the instructions for starting
- Clean the spark plug or replace it
with a new one
- Contact an authorized customer
service outlet or send the equip-
ment to ISC GmbH
- Set the choke lever to „ "
- Clean the air fi lter
- Contact an authorized customer
service outlet or send the equip-
ment to ISC GmbH
- Clean the spark plug and adjust the
electrode gap, or fi t a new spark
plug
- Contact an authorized customer
service outlet or send the equip-
ment to ISC GmbH
- Use the correct fuel mix (see fuel
mixing table)
- Contact an authorized customer
service outlet or send the equip-
ment to ISC GmbH
- Top up with oil
- Clean the oil tank cap
- Clear the oil outlet
- Top up with oil
- Clean the oil tank cap
- Clear the oil outlet
- Re-sharpen or replace the chain
- Check the chain tension
- Adjust the chain tension
- Re-sharpen or replace the chain
- Replace the chain
- Refi t the chain with the teeth facing
in the correct direction
- 30 -
Remedy
29.11.11 14:49 29.11.11 14:49