Disconnecting Wi-Fi Direct (Simple Ap) Connection; Changing The Wi-Fi Direct (Simple Ap) Settings Such As The Ssid - Epson ET-2850 Series User Manual

Adding or Replacing the Computer or Devices

Disconnecting Wi-Fi Direct (Simple AP) Connection

There are two methods available to disable a Wi-Fi Direct (Simple AP) connection; you can disable all connections
by using the printer's control panel, or disable each connection from the computer or the smart device. This
section explains how to disable all connections.
Important:
c
When Wi-Fi Direct (Simple AP) connection disabled, all computers and smart devices connected to the printer in
Wi-Fi Direct (Simple AP) connection are disconnected.
Note:
If you want to disconnect a specific device, disconnect from the device instead of the printer. Use one of the following
methods to disconnect the Wi-Fi Direct (Simple AP) connection from the device.
❏ Disconnect the Wi-Fi connection to the printer's network name (SSID).
❏ Connect to another network name (SSID).
1. Select Wi-Fi Setup on the home screen.
To select an item, use the
2. Select Wi-Fi Direct.
3. Press the OK button to proceed.
4. Press the OK button to proceed.
5. Press the
button to display the setting screen.
6. Select Disable Wi-Fi Direct.
7. Check the message, and then press the OK button.

Changing the Wi-Fi Direct (Simple AP) Settings Such as the SSID

When a Wi-Fi Direct (Simple AP) connection is enabled, you can change the Wi-Fi Direct settings such as the
network name and the password.
1. Select Wi-Fi Setup on the home screen.
To select an item, use the
2. Select Wi-Fi Direct.
3. Press the OK button to proceed.
4. Press the OK button to proceed.
5. Press the
button to display the setting screen.
u d l r
buttons, and then press the OK button.
u d l r
buttons, and then press the OK button.
>
Connecting a Smart Device and Printer Directly (Wi
177
...