Changes To Eval-Ad7606-4Sdz Section And Table 3 - Analog Devices EVAL-AD7605-4SDZ User Manual

EVAL-AD7605-4SDZ/EVAL-AD7606SDZ/EVAL-AD7607SDZ/EVAL-AD7608SDZ User Guide
EVAL-AD7606-4SDZ
The EVAL-AD7606-4SDZ
AD7606-4 mounted at U1 (see Figure 1).The
channel DAS with simultaneous sampling ADC. External signals
can be applied to V1, V2, V5, and V6. Input Connectors V5 and
V6 route to the AD7606-4
respectively.
Table 3. Link Options
Link Default Position
LK1 A
LK2 Insert
LK3 B
SL1 A
SL2 A
SL3 A
SL4 A
SL5 A
SL6 A
SL7 A
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
evaluation board is supplied with the
AD7606-4 is a 4-
V3 and V4 input channels,
Function
This link is used to select the power supply source for the evaluation board.
In Position A, the board can be powered by the supplied wall mounted switching supply using the J1
connector.
In Position B, the evaluation board must be powered by an external supply connected to the J3 terminal block.
LK2 supplies the SDP power supply from the evaluation board.
The EVAL-SDP-CB1Z is powered from the
LK3 is used to select the V
DRIVE
In Position A, the AD7606/AD7606-6/AD7606-4, AD7607, AD7608, and
In Position B, the AD7606/AD7606-6/AD7606-4, AD7607, AD7608, and
5 V V runs the device at 200 kSPS in serial interface mode.
DRIVE
In Position A, the CS signal is supplied from the SDP terminal, J2.
In Position B, The CS SMB is selected.
In Position A, the SCLK signal is supplied from the SDP terminal, J2.
In Position B, the SCLK SMB is selected.
In Position A, the STBY signal is supplied from the SDP terminal, J2.
In Position B, the STBY SMB is selected.
In Position A, the CS signal is supplied from the SDP terminal, J2.
In Position B, the CS SMB is selected.
In Position A, the RESET signal is supplied from the SDP terminal, J2.
In Position B, the RESET SMB is selected.
In Position A, the CS signal is supplied from the SDP terminal, J2.
In Position B, the CS SMB is selected.
In Position A, the CONVST signal is supplied from the SDP terminal, J2.
In Position B, the CONVST SMB is selected.
EVAL-AD7605-4SDZ
The EVAL-AD7605-4SDZ
AD7605-4 mounted at U1 (see Figure 1)The
channel DAS with a simultaneous sampling ADC. External signals
can be applied to V1, V2, V5, and V6. Input Connectors V5 and
V6 route to AD7605-4
ADP7104 5 V linear regulator.
source for the AD7606/AD7606-6/AD7606-4, AD7607, AD7608, and AD7605-4.
Rev. A | Page 5 of 15
UG-851
evaluation board is supplied with the
AD7605-4
V3 and V4 input channels, respectively.
AD7605-4 are supplied with 3.3 V V
AD7605-4 are supplied with 5 V V
is a 4-
.
DRIVE
,
DRIVE