Switching On Device; Starting Headlamp Test - Bosch HTD 8 Series Original Instructions Manual

3. Turn the column with the light box until the two
reference points coincide with the line projected by
the alignment laser.
4. Switch off the alignment laser.
"
The beamsetter is correctly aligned if the laser beam
is in parallel with two symmetrical reference points on
the front of the vehicle.
Fig. 21: Aligning the device with the vehicle
!
In the event of poor laser beam reflection, a wing
cover must be placed on the vehicle for example to
permit better detection of the laser beam.
5.5

Switching on device

!
The "Battery charge" icon on the LCD shows when
the battery is flat. The beamsetter then has to be
charged with the battery charger. The device can
also be operated with the battery charger but the
battery is not charged in this case.
1. Press the "ON-OFF" key. This is located on the side
of the light box.
Fig. 22: Switching on the device
1 On/Off key
 The device is switched on.
2. Wait a few seconds for completion of the device
self-test and run-up of the visualisation.
3. The start mask is displayed.
Robert Bosch GmbH
Operation | HTD 8xx | 33
Fig. 23: Start mask
$
Options menu: Visualisation options and settings.
$
Applications menu: Headlamp checking/
adjustment.
5.6

Starting headlamp test

1. Press the Applications key in the start mask.
 The "Applications" menu opens up.
Fig. 24: "Applications" menu
2. Enter the plate number if required. Continue with
step 6 for testing without plate number.
3. Press the Plate number key.
 An alphanumeric keypad appears on the screen.
Fig. 25: Entering plate number
4. Enter the plate number of the vehicle.
5. Press OK.
 The "Applications" menu appears again.
i
Official testing can only be selected if the
beamsetter is being operated in a network.
The device then receives the vehicle settings from
the PC.
en
|
1 692 104 611 2014-10-15