Table of Contents
Advertisement
61200176L3-1
11. Enter the IP address and Netmask parameters of the access server at
the remote site. This creates a static route to the access server's net-
work which is entered into the Express 4110/4120's IP route table.
12. Move the cursor over the RIP menu. Check with the network admin-
istrator for the type of routing protocol used. The Express 4110/4120
supports RIP versions 1 and 2. The protocol is set in the Protocol
parameter.
13. Select Yes for the Triggered parameter. This prevents periodic RIP
updates that keep the ISDN link from going "idle."
14. Select Yes for the Retain parameter. This allows the routes learned
from the access server to be saved in the IP routing table. Access to
any of those networks from the workstation will cause this profile to
be dialed.
15. Use the left arrow to get back to the previous menu. Use the down
arrow to view the IPX menu parameters in the right pane.
16. This is similar to steps 13 and 14. Select Yes for Triggered and Yes for
Retain. This allows the ISDN link to go to an idle state and permits
the Express 4110/4120 to "spoof" the server information obtained
from the access server. A similar configuration must be selected on the
access server.
17. Use the arrows to get the Dial Out menu parameters for this profile.
18. Enter the phone number of the access server in Number 1. If config-
ured by the administrator to use two B-channels using Multilink PPP,
set the Initial Channels field to 2. Some PPP protocols, if they exist
in the access server, will allow the second channel to come into play
only if the bandwidth is needed. If this is the case, the Express 4110/
4120 will automatically negotiate this with the access server.
19. Now move to the Bandwidth menu for this profile. Once there, use
the right arrow to move to the On Demand submenu.
20. Set the Mode parameter to On. This enables the dynamic bandwidth
features of the Express 4110/4120.
21. Select the Idle Timeout parameter and enter the number of seconds
the Express 4110/4120 should wait before hanging up the connection
when no traffic is present. A value of 120 seconds is typical. A value
of 0 means never idle the link.
22. All the parameters for this Connection List profile are complete. To
save them, press the left arrow to get to the top (main) menu; when
prompted Save Connection List changes? enter y.
Express 4110/4120 User Manual
Quick Startup Guide
Quick Start-5
Advertisement
Table of Contents
Troubleshooting
