Operation - ADJ SWEEPER BEAM QUAD LED User Manual

Sweeper Beam Quad LED
Operating Modes: The Sweeper Beam Quad LED can operate in three different modes. In each
mode you can run the fixture as a stand alone fixture or in a primary/secondary confiugration.
This next section will detail the differences in the operating modes.
Sound Active mode - The fixture will react to sound, chasing through the built-in programs.
Show mode - Choose 1 or 12 show modes to run.
DMX control mode - This function will allow you to control each individual fixtures traits with a stan-
dard DMX-512 controller such as the Elation® Show Designer.™
Primary-Secondary Operation - This function will allow you to link up to 16 units together and
operate without a controller. The units will be sound activated. In Primary-Secondary operation, one
unit will act as the controlling unit and the others will react to the controlling units programs. Any unit
can act as a Primary or as a Secondary.
1. Using approved DMX data cables, daisy chain your units together via the XLR connector on the
rear of the units. Remember the Male XLR connector is the input and the Female XLR connec-
tor is the output. The first unit in the chain (primary) will use the female XLR connector only, and
the last unit in the chain will use the male XLR connector only. For longer cable runs, it is strongly
recommended to use a terminator on the last unit.
2. Set the Primary unit to your desired operating mode, then set the unit to the Primary setting.
3. For the Secondary units press the MENU button until "SCND" is displayed, and Press ENTER.
Set the Secondary units to either "SEC1" or "SEC2".
4. The secondary units will now follow the primary unit.
Universal DMX Control: This function allows you to use a universal DMX-512 controller to control
the chases and patterns, dimmer and strobe. A DMX controller allows you to create unique pro-
grams tailored to your individual needs
• The Sweeper Beam Quad LED has 4 DMX Channel Modes: 1 Channel, 6 Channels, 35 Channels,
or 39 Channels. See the Channel Mode sections of this manual for detailed descriptions of the
DMX values and traits.
To control your fixture in DMX mode, follow the set up procedures shown in the Set Up section of
•
this manual, as well as the set up specifications that are included with your DMX controller.
• Use the controller's faders to control the various DMX fixture traits.
• This will allow you to create your own programs.
Follow the instructions in the System Menu section of this manual to set the DMX address.
•
• For longer cable runs (more than a 100 feet) use a terminator on the last fixture.
• For help operating in DMX mode consult the manual included with your DMX controller.
Sound Active Mode: This mode allows either single unit or several units linked together to run to the
beat of the music.
1. Tap the MENU button until "SOUN" is displayed, and press ENTER.
2. Tap the UP or DOWN buttons to choose either OFF or ON, and press ENTER.
3. Press and hold MENU for 3 seconds to confirm. To adjust sound sensitivity, follow the directions
shown in the System Menu section of this manual.
4. The optional UC3 Controller (not included) may be used to control various functions.
ADJ Products, LLC - www.adj.com - Sweeper Beam Quad LED User Manual Page 13

Operation