System Menu - ADJ SWEEPER BEAM QUAD LED User Manual

Sweeper Beam Quad LED
System Menu: When making adjustments press ENTER to confirm your setup and then press
and hold the MENU button for at least 3 seconds. To exit without making any adjustments
press the MENU button.
ADDR - DMX Address Setting.
1. Press the either the MENU, UP, or DOWN buttons until "ADDR" is displayed, and press ENTER.
2. The current address will now be displayed and flashing. Press the UP or DOWN buttons to find
your desired address. Press ENTER and then press and hold the MENU button to set your de-
sired DMX address.
CHND - This will let select your desired DMX channel mode.
1. Press the either the MENU button until "CHND" is displayed, and press ENTER. Either "1CH",
"6CH", "35CH", or "39CH" will be displayed.
2. Press the UP or DOWN buttons to choose your desired DMX mode and press ENTER to confim
and exit.
SCND - This will let you set unit as a primary or a secondary in a primary/secondary configu-
ration.
1. Press the MENU button until "SCND" is displayed, and press ENTER. Either "PRI," "SEC1," or
"SEC2" will be displayed.
2. Press the UP or DOWN buttons until your desired setting is displayed, press ENTER and then
press and hold the MENU button to confim.
NOTE: In a Primary/Secondary configuration, setting the Secondary units to "SEC2" will cause the
primary and secondary units to have contrasting movements.
SET - This will set the Sweeper to a preset angle.
1. Press the either the MENU button until "SET" is displayed, and press ENTER. Either "150", "120",
or "90" will be displayed. These are the preset angles.
2. Press the UP or DOWN buttons to choose your desired angle and press ENTER to confim and
exit.
SHND: SH 0 - SH16 - Show modes 0-16 (Factory programs). Show mode can run with or with-
out sound active mode.
1. Press the MENU button until "SHND" is displayed, and press ENTER.
2. "Sh X" will now be displayed, "X" representing a number between 0-16. Programs 1-16 are fac-
tory programs, while "Sh 0" is random mode. Press the UP or DOWN buttons to find your desired
show.
3. When you have found your desired show press ENTER, then press and hold the MENU button for
at least 3 seconds to activate.
SOUN - Sound Active mode.
1. Press the MENU button until "SOUN" is displayed, and press ENTER.
2. The display will show either "ON" or "OFF". Press the UP or DOWN buttons to select "ON" to
activate sound active mode, or "OFF" to deactivate sound active mode.
3. Press ENTER, and then press and hold the MENU button for at least 3 seconds to activate.
ADJ Products, LLC - www.adj.com - Sweeper Beam Quad LED User Manual Page 9

System Menu