Advertisement
Step 2 Wood Stud
CAUTION:
Avoid potential personal injuries and
property damage!
● Drywall covering the wall must not exceed
5/8 in. (16 mm)
● Minimum wood stud size: common 2 x 4 in.
(51 x 102 mm) nominal 1½ x 3½ in. (38 x 89 mm)
CAUTION:
Avoid potential personal injury or
property damage! All lag bolts
MUST BE firmly
08
tightened to prevent unwanted movement of the wall
plate
01
.
CAUTION:
Ensure the wall plate is securely
fastened to the wall before continuing on to the next
step.
Step 3
06
02
07
04
02
07
Install arm extensions
Adjustments
To adjust TV tilt, loosen the handle on
the arm plate, tilt TV to desired angle,
and retighten handle to secure.
2-1
1 6 i n
.
( 4 0 6
m m )
Locate your studs. Verify and mark the center of
the studs by fi nding the stud edges using an awl,
a thin nail, or an edge-to-edge stud fi nder.
Step 4
07
Hang TV with
brackets
03
onto the upper
arm extensions
04
10
02
and
03
07
05
06
01
and
and end caps
.
02
03
04
2-2
U P
01
Position the wall plate
at your desired height
01
and line up the holes with your stud center line.
Level the wall plate and mark the holes.
05
05
01
03
.
03
05
Note: TV brackets
05
01
faceplate of the arm and be centered.
To adjust TV level, loosen the 2 bolts on
the rear of the arm plate, adjust level,
and retighten to secure.
2-3
3 in. (75 mm)
7/32 in.
(5.5 mm)
Drill pilot holes using a 7/32 in. (5.5 mm) diameter
drill bit.
IMPORTANT: Be sure to drill into the center of the
stud.
IMPORTANT: Pilot holes must be drilled to a depth
of 3 in. (75 mm).
Step 5
02
03
Secure TV with brackets
05
and screws
.
21
must span the
07
Ensure that the bracket clips
brackets
cannot slide side-to-side.
05
Milestone AV Technologies and its affi liated corporations and subsidiaries (collectively,
"Milestone"), intend to make this manual accurate and complete. However, Milestone
makes no claim that the information contained herein covers all details, conditions,
or variations. Nor does it provide for every possible contingency in connection with
the installation or use of this product. The information contained in this document
is subject to change without notice or obligation of any kind. Milestone makes no
representation of warranty, expressed or implied, regarding the information contained
herein. Milestone assumes no responsibility for accuracy, completeness or suffi ciency
of the information contained in this document.
©2015 Milestone AV Technologies. All rights reserved. ECHOGEAR is a Milestone
brand.
ECHOGEAR and the ECHOGEAR logo are trademarks of Milestone.
Made in China.
Milestone Global Headquarters • 6436 City West Parkway • Eden Prairie, MN 55344 USA
2-4
01
08
Install wall plate
using lag bolts
and
01
08
washers
. Tighten the lag bolts
only until
09
08
they are pulled firmly against the wall plate
05
05
07
02
02
03
07
to the lower arm extensions
and
with the bracket clips
02
03
and screws
are firmly attached and that the TV with
21
07
6901-002429 02
09
.
01
21
Advertisement
