Using The Cassiopeia Usb Cable; To Connect To A Computer Using The Cassiopeia Usb Cable - Casio Cassiopeia E-200 Getting Started Manual

Casio cassiopeia e-200: users guide

Hide thumbs Also See for Cassiopeia E-200:

Table of Contents

Using the CASSIOPEIA USB Cable

You can use the CASSIOPEIA USB cable to connect the CASSIOPEIA directly to a

computer.

Important

• See "Required System Configuration" on page 44 for the computer system that is

required for direct USB connection.

• The illustration below is just one possible connection configuration. The location and

layout of USB ports vary from computer to computer. See the documentation that

comes with your computer for full details on connecting cables to it.

• You must have ActiveSync installed on your computer in order to exchange data with

the CASSIOPEIA over a USB connection. See the ActiveSync Help for details about

setting up and using ActiveSync.

Important

Before connecting your CASSIOPEIA to a computer, make sure you first install the

ActiveSync on your computer. Use the steps below to connect the CASSIOPEIA to

your computer when prompted to do so during the software installation procedure.

1. Plug the USB cable into the USB port of your computer.

2. Turn off your CASSIOPEIA.

3. Connect the other end of the USB cable to your CASSIOPEIA.

• To disconnect the USB cable, squeeze in on the buttons on either side of the plug to

unlock it, and then pull.

USB port

CASSIOPEIA USB cable

Table of Contents