Notes; Changing The Temperature Unit; Saving And Loading Favourites; Preventing Running While Unloaded - Miele PRI 210 Operating Instructions Manual

en - Notes

Changing the temperature unit

The temperature unit display can be changed from °C to °F by Miele Service.

Saving and loading favourites

The following steps describe how to save and load the most frequently used combinations
of ironing temperature and roller speed on the  button.
Saving favourites
First set the desired ironing temperature and roller speed (see "Ironing" in "Using the

ironer").
Then press and hold the  button until it flashes once.

The set combination of ironing temperature and roller speed is then saved to the  button.
Loading favourites
Tap the  button to load a favourite.

The ironer's roller speed and ironing temperature are then set to the combination of values
saved to the button.
Exiting favourites
Tap the  button to exit a favourite setting.

The set ironing temperature and roller speed set previously are loaded.

Preventing running while unloaded

If you interrupt the ironing process for a certain period of time, press the  button to enter
pause mode or alternatively press the  button to switch off the ironer. This prevents any
unnecessary running while unloaded (i.e. the ironer operating without laundry) and means
that much less strain is exerted on the ironing cloth and the drive.
If the ironer is operated while unloaded over an extended period of time, this will result in
the roller covering having a significantly shorter service life.

Continuing ironing after a power outage

After a power outage, press the  button.

The flatwork ironer is switched back on.
Activate the finger guard.

Press the  button.

Ironing can then be resumed.

Peak load/energy management

An option is available for connecting the ironer to a peak-load/energy management sys-
tem. If the peak-load/energy management system is active, the ironer's heater element
switches off and either  or . flashes in the display. The residual heat in the heater
plate means that ironing can continue until the ironer goes into Pause mode ().
180