Step 6: Snowblower Installation - Sears CRAFTSMAN C 151 61672 3 Owner's Manual

STEP 6
SNOWBLOWER INSTALLATION:
Refer to parts breakdown
identification.
WARNING
TO PREVENT INJURIES:
Stop the motor.
Apply parking brake.
Remove the ignition key.
Disconnect the wire from the spark plug(s) and
keep away from spark plug(s) to prevent accidental
starting.
Attach the snowblower to the subframe as shown.
Make sure the snowblower is pushed in until locked
into place by the springs (item 4).
Lift the snowblower. Turn the tension arm (item 1)
towards the back. Install the chain (item 2) (of the
helper spring) on the tip (item 3) of the left support
intended for this purpose. Turn the tension arm
towards the front to apply tension on the spring.
Lower the snowblower.
CAUTION
The belt tension arm and lift assist spring arm are
spring loaded & need to be held firmly while
displacing to prevent injury
NOTE: See belt installation instructions in the
Maintenance section.
CAUTION
Never use the snowblower without the belt guard.
ASSEMBLY
section for parts
.
Install snowblower and lift assist spring
WARNING
TO PREVENT INJURIES:
It is the person who installs the drive mechanism
responsibility to make sure that when the clutch
is disengaged that all moving parts stop.
For more information, do not hesitate to contact
the technical support.
20