Sears CRAFTSMAN C 151 61672 3 Owner's Manual page 12

ASSEMBLY
If necessary, slide the shim (item 20, previous page)
between the tractor frame and the support, in line with
hole (item 9 or item 11). (Make sure that the shim
stays perpendicular with the top of the support).
Slightly tighten the screws and bolts.
Make sure that the brace pin stays straight and does
not come into contact with any part of the tractor (ex:
the engine belt when mower deck is in raised posi-
tion). If there is a contact, turn the brace pin upside
down.
MOWER BRACKET
If you have removed the original supports from the
tractor, in order to install the mower brackets (item
19) (included in this kit) inside the support; insert two
hex. bolts 3/8 x 1 1/4" (item 20) (the heads on the
outside) in the top holes of the right support .
From the inside of the support, place the shim (item
21; notice orientation) and the mower bracket (item
19) on the bolts. Secure with two flange nuts.
Do the same operation on the left side.
Tighten firmly.
Reinstall the parts:
Install the mower brackets inside the support and
other parts if applicable.
Reinstall the parts previously removed in their original
position.
10