Advertisement
The EASTWOOD PUNCH & BEAD DIE SETS will punch a clean hole and produce a smoothly
radiused, raised bead in aluminum and mild steel in a choice of 4 sizes.
This tool is designed to be used on single thickness sheet metal of thicknesses noted below.
FINISHED HOLE DIMENSIONS
#20533
1" Die Set
#20356
1.5" Die Set
#20534
2" Die Set
#20535
2.5" Die Set
MAXIMUM MATERIAL THICKNESS
Aluminum
Mild Steel
Stainless Steel
SAFETY INFORMATION
In this manual, on the labeling, and all other information provided with this product:
WARNING indicates a hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION used with the safety alert symbol, indicates a hazardous situation which,
if not avoided, could result in minor or moderate injury.
2
1" I.D. Hole x 1-1/2" Dia. x 0.05" High Bead
1-1/2" I.D. Hole x 2" Dia. x 0.05" High Bead
2" I.D. Hole x 2-1/2" Dia. x 0.05" High Bead
2-1/2" I.D. Hole x 3" Dia. x 0.05" High Bead
14 Ga (.064")
16 Ga (.060")
19 Ga (.044")
READ INSTRUCTIONS
Read this entire manual before set up and use of this tool.
Save this instruction manual for future reference.
• Do not use impact wrenches with this tool.
• Always wear ANSI rated eye protection when using this tool.
• Pinch Hazard! Keep fi ngers away from the moving parts when operating.
• Wear appropriate work gloves and protective clothing. Sheet metal will often
have sharp edges which can cause cuts to hands and arms.
Never attempt to use this tool on materials thicker than those shown as
serious tool damage can result.
Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com
INJURY HAZARDS
Advertisement
