Changing Midi Settings - Casio CTK-496 User Manual

TRANSPOSE/TUNE/MIDI

Changing MIDI Settings

This keyboard lets you change the settings of two MIDI
parameters: TONE MAP and KEYBOARD CHANNEL.
To change MIDI parameters
1
Press the TRANSPOSE/TUNE/MIDI button either
three or four times to select the parameter you want.
Press the TRANSPOSE/TUNE/MIDI button three
times: KEYBOARD CHANNEL.
Press the TRANSPOSE/TUNE/MIDI button four times:
TONE MAP.
Example: To select the TONE MAP parameter.
2
Use [+] and [–] to change the setting of the
parameter.
Example: To change the TONE MAP parameter value to
"G" (GM).
• If you accidentally go past parameter you want, keep
pressing the TRANSPOSE/TUNE/MIDI button until
parameter you want reappears on the display.
• If you leave the parameter selection screen on the
display for about five seconds without doing
anything, the parameter selection screen is
automatically cleared.
627A-E-033A
Parameters and Their Displays
I KEYBOARD CHANNEL (Basic Channel) (Default: 01)
This parameter specifies the keyboard MIDI message send
channel.
I TONE MAP G/N (Default: N)
N: This setting specifies the normal tone map, which allows
receipt of a program change value in the range of 0 to 99.
Only tones that correspond to the 100 built-in tones of this
keyboard can be played, and tone numbers outside this
range are ignored.
G: This setting specifies the General MIDI tone map, which
allows receipt of a program change value in the range of 0
to 127. Each of the 128 General MIDI tones is automatically
assigned to one of the keyboard's 100 built-in tones as
shown on page A-2. Select this setting when you want to
listen to General MIDI data from a computer or other
external equipment.
NOTE
• Playing a Song Bank tune causes all MIDI parameters
to revert to their default settings.
• Song Bank data cannot be sent as MIDI data.
• MIDI messages cannot be received while the keyboard
is in the Song Bank Mode.
MIDI
[+]/[-]
E-31