SAFETY AND INSTRUCTION MANUAL 3. ASSEMBLED PRODUCT DIMENSIONS Identification Size (cm) 1. INTRODUCTION This Manual is for grill model TGP-6000. Please disregard information regarding parts not included with your grill as your specific model has parts compatible with your country’ s standards. Do not discard this Manual as it contains important information about the product (installation, use, maintenance and cleaning), as well as warnings and instructions for safe and proper use.
4. LIST OF GAS GRILL PARTS ITEM DESCRIPTION QUANTITY Back right leg Upper back panel Lower back panel Side panel Caster wheels Front right leg Lower base Lower supporting beam Lower magnet Door Front left leg Upper supporting beam Back left leg Left side barrier Base for cutting board Burner grate...
5. ASSEMBLY INSTRUCTIONS STEP 3 5.1. INITIAL CHECK Attach the upper supporting beam (item 30) to the front legs using 4 screws (item AA) as shown in figure 3. To quickly and successfully assemble your grill, please follow the instructions below: •...
Page 8
STEP 6 STEP 9 Position the central unit (item 38) on the assembled structure and attach it using 4 Remove the four screws that are pre-assembled on the base of the side burner as screws (item AA), as shown in figure 6. shown in figure 09 A.
Page 9
STEP 10 STEP 12 Attach the gas valve (item 36) to the knob base (item 17) together with the right side Connect the electrode wire (item 9) of the side burner gas valve (item 36) to the protector (item 18) using 2 screws (item BB) as shown in figure 11. ignitor electrode that is assembled next to the side burner, as shown in figure 15.
Figure 18 Ref.: 26500/061 Figure 19 Figure 22 Access our website for more information: www.tramontina.com.br 6. GENERAL SAFETY INFORMATION 6.1. SAFETY SYMBOLS This symbol is used to call attention to important safety information. • Words such as DANGER, ATTENTION or WARNING are used with the SAFETY symbol.
• The use of pots on the grill is not recommended. For this cooking option, only • Never store the gas tank or other combustible or flammable materials inside the the use of Tramontina anodized grill grates or woks is recommended. For pots, use grill itself...
Tramontina conversion kit for natural gas and contact the • Always keep the grill at least 1 meter away from all walls whenever it is in use or authorized technical support service to perform the installation.
• If there is a leak, contact the nearest technical support, authorized representative 8) After use, turn the control knob clockwise until the indicator on the knob is or Tramontina’s customer service. aligned with the “OFF” position. • Some gas leak test solutions can be corrosive, including mild detergent and 9) Turn off the gas supply after use.
3 hours. • If a problem with the ignition system persists, contact technical support, an authorized representative or Tramontina’s customer service. • Failure to comply with these warnings and precautionary measures could result in a fire or an explosion causing damage to property, serious bodily injury, or even death.
4 Do not light any type of flame, spark, matches, or any other electrical equipment. • In order to keep food juicy, we recommend using Tramontina spatulas or tongs 5 Wait at least five minutes for the gas to dissipate before relighting the grill.
10.3. DRIP TRAY AND GREASE CUP TONGS Stainless steel with rubberized handles for protection. To clean the drip tray and the grease cup, first make sure that neither of them is hot. • Wash and dry the item thoroughly before first use. Then, remove the grease cup first and dispose of the oil according to the regula- •...
• After cleaning, for best results, we recommend using Tramontina’s polish and can damage the finish. The use of Tramontina brushes with metal bristles is always stain removal paste to polish and remove stains. This product can be purchased on recommended.
If flames are not evenly distributed along the burner or display incorrect coloring, follow the burner maintenance instructions. Each Tramontina product you have at home is the result of careful work, designed to transform our entire manufacturing process into action towards making a better 10.12.
Is the gas flow insufficient? Set the control knob to “MAX”. NOTE: If the problem persists, contact technical support, an authorized representative or Tramontina´s customer service. 13. WARRANTY • Damaged parts (crushed or scratched) that occur due to accidents during trans- 13.1.
Need help?
Do you have a question about the TGP 6000 and is the answer not in the manual?
Questions and answers