Fluke i40s-PR Instruction Sheet

LIMITED WARRANTY AND LIMITATION OF LIABILITY
This Fluke product will be free from defects in material and workmanship for one
year from the date of purchase. This warranty does not cover fuses, disposable
batteries, or damage from accident, neglect, misuse, alteration, contamination, or
abnormal conditions of operation or handling. Resellers are not authorized to extend
any other warranty on Fluke's behalf. To obtain service during the warranty period,
contact your nearest Fluke authorized service center to obtain return authorization
information, then send the product to that Service Center with a description of the
problem.
THIS WARRANTY IS YOUR ONLY REMEDY. NO OTHER WARRANTIES, SUCH
AS FITNESS FOR A PARTICULAR PURPOSE, ARE EXPRESSED OR IMPLIED.
FLUKE IS NOT LIABLE FOR ANY SPECIAL, INDIRECT, INCIDENTAL OR
CONSEQUENTIAL DAMAGES OR LOSSES, ARISING FROM ANY CAUSE OR
THEORY. Since some states or countries do not allow the exclusion or limitation
of an implied warranty or of incidental or consequential damages, this limitation of
liability may not apply to you.
Fluke Corporation
P.O. Box 9090
Everett, WA 98206-9090
U.S.A.
11/99
Shop for Fluke products online at:
Fluke Europe B.V.
P.O. Box 1186
5602 BD Eindhoven
The Netherlands
MyFlukeStore
www.
Introduction
The i40s-PR 1750 40A AC Current Clamp operates with the Fluke 1750 Power
Recorder. It supplies accurate nonintrusive measurement of ac current. The probe
has a current range from 0.05 A to 40 A. The frequency range is 40 Hz to 5 kHz. The
clamp is approved for CAT III 600 V.
Contacting Fluke
To contact Fluke, call:
USA: 1-888-44-FLUKE (1-888-443-5853)
Canada: 1-800-36-FLUKE (1-800-363-5853)
Europe: +31 402-675-200
Japan: +81-3-3434-0181
Singapore: +65-738-5655
Anywhere in the world: +1-425-446-5500
USA Service: 1-888-99-FLUKE (1-888-993-5853)
Or, visit Fluke's website at www.fluke.com.
To register your product, visit http://register.fluke.com.
Safety Information
 Safety Information
To prevent electrical shock or personal injury:
● Carefully read all instructions.
● Use the product only as specified, or the protection supplied by the
product can be compromised.
● Comply with local and national safety codes. Use personal protective
equipment (approved rubber gloves, face protection, and flame-resistant
clothes) to prevent shock and arc blast injury where hazardous live
conductors are exposed.
● Hold the product behind the tactile barrier.
● Before each use, examine the product. Look for cracks or missing pieces
of the clamp housing or output cable insulation. Also look for loose or
weakened components. Carefully examine the insulation around the jaws.
● Do not exceed the Measurement Category (CAT) rating of the lowest rated
individual component of a product, probe, or accessory.
● Use the Clamp only on insulated conductors.
● Use caution around bare conductors or bus bars.
● Do not touch the conductor.
● Do not touch voltages > 30 V ac rms, 42 V ac peak, or 60 V dc.
● Do not use the product around explosive gas, vapor, or in damp or wet
environments.
For more information about the category rating, see the 1750 Power Recorder
Getting Started Guide.
PN 3950028 January 2011
© 2011 Fluke Corporation. All rights reserved. All product names are trademarks of their
respective companies. Product specifications are subject to change without notice.
1.877.766.5412
.com
i40s-PR 1750 40A
AC Current Clamp
Instruction Sheet