Advertisement
1
Remove the counterweight and anti-skating weight from the
tonearm. Secure the tonearm using the supplied red wire.
5
Loosen the lower screw just a little to be able to
rotate the RCA box.
9
Loosen the upper nut by 3mm.
13
Rotate the RCA box back to the initial position.
2
Remove the main platter.
6
Carefully rotate the RCA box...
10
Check if the gap is sufficient.
14
Tighten both screws.
3
Bring the turntable in an upright position to have access to
both the upper- and underside.
7
... until the 5.5mm nut is accessible.
11
Slide in the VTA spacer from behind until the spacer
is flush with the arm base.
15
Reseat main platter.
4
Underside: remove upper screw while holding the tonearm
from the other side.
8
Using the PH1 and 5.5mm nut wrench, loosen the tonearm
(base) by 3mm.
12
Tighten both nuts. Please make sure to hold the
antiskating support with your finger while doing so.
16
Remove the red securing wire and re-install
counterweight and anti-skating weight.
Advertisement
